When inferior or inappropriate.
Stucco peeling from a concrete retaining wall.
Masonry walls whether built of stone brick or cement all absorb moisture and react to stresses due to their weight and age.
To prep the wall for stucco repair dig back the dirt to below the bottom of the stucco wall.
It s the strongest cement plaster found in the.
You may need to trench perpendicular to the wall so that later when you rinse the walls excess water can flow away.
Moisture from the soil ca also enter the stucco from the lower part of the walls.
I couldn t pass up the opportunity to show this bare concrete retaining wall and an idea that would improve the look of the home exterior and not have it be the eyesore of the neighborhood.
Check out our recommended tools right here.
Apply a thin third layer of stucco over the concrete retaining wall.
Under the right circumstances mold can invade stucco.
You could just remove the loose stucco clean the bare wall then apply weldbond white glue mixed with water at a 10 to 1 ratio.
How to fix a peeling masonry wall.
Apply the first coat of stucco to the concrete surface.
Apply the bonding agent let it dry then reapply the bonding agent then apply your coating.
Allow the wall to dry for 48.
Alternatively you can use the trowel to create circular patterns in the stucco s surface.
Next scrape and brush away all the soft loose deteriorated paint and stucco until you get to the good hard stucco.
But you might find that down the road the work you have done is fine but other areas might just peel.
Use the flat finishing trowel to spread the stucco evenly across the surface.
Allow the scratch coat to harden slightly.
A little stucco and a few natural rocks to cap it off and you ve got it.
The scratch coat should be between 1 4 and 1 2 inch thick.
This first coat is known as the scratch coat this coat helps the final coat bond properly to the wall.
This coat should be about 1 8 inch thick.
This can get behind a wall and in some cases become trapped where it slowly begins to rot.